iX12 Airware Change Log

Version 1.01.02

New Features

 When saving a model file as a Template, a message appears confirming that the

model was successfully saved

 Telemetry Shortcut - On the Dashboard, when a telemetry screen is selected,

long pressing the telemetry ICON at the top of the page will return to the

Dashboard screen

 In Sailplane mode, when on the Flight Mode screen changing the flight display

name also changes the name in the flight mode matrix for easier identification.

 Telemetry warnings for receiver voltage and Flight log are now displayed on the

Audio Events Telemetry warnings screen

Corrections & Improvements

 When switching to stick modes 1 or 3 the trim boxes displayed on the dashboard

now properly switch to the correlating position of the trim switches

 The on screen response when adjusting the Dual Rate and EXPO values when

using the sliders and + - buttons has been improved.

 Programmed mixes are now properly reset to defaults when inhibited.

 In Throttle Curve, the Throttle Delay button has been removed. Throttle Delay is

only available in Throttle Cut. It was mistakenly displayed in the Throttle Curve

screen in version 1.00.03

 Several timer issues have been corrected including the 1 minute timer

announcement

 When using a Curve Mix the mix values now properly correlate to the servo

output values on the servo monitor

 When using headphones or speakers, the audio is only output on the device and

not the transmitter

 Several issues with the Sequencers have been corrected

PAGE 1
Version 1.01.02 New Features  When saving a model file as a Template, a message appears confirming that the model was successfully saved  Telemetry Shortcut - On the Dashboard, when a telemetry screen is selected, long pressing the telemetry ICON at the top of the page will return to the Dashboard screen  In Sailplane mode, when on the Flight Mode screen changing the flight display name also changes the name in the flight mode matrix for easier identification.
PAGE 2
 In Servo Setup - Speed, the right and left directions adjust the speed in that proper direction regardless of the servo reversing position  In screens where the keyboard is available, the Cap lock defaults are now consistent.  Battery transmitter voltage now displays in 1/10 volt increments at 4.0V.  Model Timers now correctly trigger when reassigned to various switches and buttons.  The Inactivity Alarm is no longer active when using other applications.
PAGE 3
 In Helicopter Mode, when reversing the collective type the throttle warning now properly warns high throttle setting
PAGE 4
Version 1.00.