User Manual

SPEKTRUM TELEMETRY

Signal and Battery Voltage

Signal strength and battery voltage is built into the telemetry module

and no further attachment of sensors is necessary. The telemetry module

must be properly hooked up to the receiver, and with the handheld unit

and receiver bound together. Signal strength and battery voltage will

be displayed when the receiver and handheld units are turned on.

Signal Lap # Lap Time

Speed/RPM Voltage Temperature









Note: The voltage displayed is the receiver voltage. This

is especially useful for nitro cars in alerting you to change

your receiver pack before your vehicle goes into failsafe due

to low battery pack voltage. If you wish to monitor another

voltage source (like the drive batteries in an electric car), a

voltage harness is provided. The voltage harness replaces the

telemetry lead and the open wires must be attached (soldered)

to the desired voltage source that you wish to monitor.

Note: The source must be above 3.2 volts.