User Manual

19
SPEKTRUM TELEMETRY
Temperature Sensor (Nitro)
A temperature sensor loop is provided in the nitro system that wraps
around the head of the engine to monitor head temperature. This is
useful in tuning engines and in preventing damaging over-lean runs.
Temperature Sensor Installation (Nitro)
• Install the loop as shown around the cylinder of the engine. It is
best to place the sensor near the point at which the head meets
the cylinder to get the most accurate consistent readings.
• Plug the temperature sensor into the port marked E in the telemetry
module. The handheld unit should now display room temperature.
Temperature Sensor (Electric)
A Thermister type temperature sensor is included in the electric
system that can be taped to the battery or motor to monitor
real time temperature. Transparent tape can be used to attach
the sensor for temperatures up to approximately 250°F high.
Temperature tape is needed for temperatures exceeding 250°F.
Temperature Sensor Installation (Electric)
• Tape the temperature sensor to the desired area you
wish to monitor (normally the batteries or motor).
• Plug the temperature sensor into the port marked E in the telemetry
module. The handheld unit should now display room temperature.