User Manual

7
SPEKTRUM TELEMETRY
Store Lap
Signal Lap # Lap Time
Speed/RPM Voltage Temperature


During a run, current lap information is stored in the telemetry module.
(Not in the handheld unit). This information is then displayed on the
handheld unit. To reset the lap information, it is necessary to turn
the receiver off then on. This will reset the lap information and the
screen will display 0 laps at 0:00.00 seconds. Previous laps will
remain in memory of the handheld unit until it is power cycled.
To store lap information in the handheld unit for future review,
the Store Laps screen is provided. This screen allows you to
store the lap information (number of laps and the individual
lap times) from the presently recorded run that’s stored in the
telemetry module memory, and to recall that information at a
later date even if the receiver and handheld unit is turned off.
To store lap information, access the Store Lap screen by pressing
the  button until Store Lap appears on the screen, then press the
– or + button to store the lap information from the previous run.
Note: If the handheld is turned off before the laps
are stored, the lap information will be lost.
Recall Lap
Signal Lap # Lap Time
Speed/RPM Voltage Temperature


The Recall Lap screen allows you to recall the lap information (number
of laps and the individual lap times) from the previously stored
information from Store Laps above. To recall laps, lap information must
have been previously stored in the Store Laps screen (see above).
To access the Recall Laps screen, press the
 button until
Recall Laps appears on the screen, then press the + or- button
to recall the lap information. Reading laps will appear and the
screen will display the lap # and time. Pressing the – or +
button will allow you to scroll up or down through the laps.