User Manual

Antenna

4. With the transmitter off, place the transmitter steering wheel, throttle trigger and

auxiliary channels in their desired fail-safe positions (normally brake and straight-

ahead steering).

5. Press and hold the bind button on the transmitter while turning on

the transmitter.

6. Release the bind button after the green LED ﬂashes.

After several seconds the LED on the receiver and the LED on the transmitter will quit

ﬂashing and remain solid, indicating that the binding process was successful. Once binding

is complete, the system will automatically connect.

At 8.5 inches in length, the receiver antenna is signiﬁcantly shorter than conventional

antennas. The receiver has provisions that allow the antenna to exit the top of the receiver

or at the end of the receiver. To switch antenna positions, it is necessary to open the case

to change the antenna exit position. Like all antennas, it’s important to mount the antenna

vertically. In most cases the antenna can be mounted inside the body with no loss of range.

Mount the receiver antenna as recommended by the manufacturer of the vehicle, however, it

may be necessary to trim the plastic antenna tube (included with your vehicle) to allow the

antenna to extend at least 1/2” past the tip of the tube.

Note: If desired, the antenna can be shortened (cut) to exactly 3.6” with negligible loss of

range, and in some applications the short 3.6” length will make installation easier.

Binding

(continued)

Bind Button