Instruction Manual

23SPEKTRUM DX3R PROGRAMMING GUIDE
User Name
01: Model 01
Bi nd
BIND
Plac e t h e RX
into b i n d
mode f i r st.
≤
6. Rotate the roller to highlight BIND
7. With the steering wheel, throttle stick and Aux
channel (if applicable) in the desired preset failsafe
positions, press the roller to initiate the bind process
and to store the failsafe positions. BIND will flash for
a few seconds; then the transmitter will beep,
indicating the process is complete. The LED on
the receiver should now be solid, indicating a
successful bind has taken place.
8. Remove the bind plug and store it in a
convenient place.
Note: The only time it’s necessary to do a
rebind is when different failsafe positions are
desired, or if the receiver is to be bound to a
different model memory.
Note: Some Spektrum receivers, like the
AR3000, use a bind button rather than a bind
plug. The binding process is the same with
this receiver, however, instead of inserting the
plug before powering up the receiver, press
and hold the bind button while powering up
the receiver to enter the bind mode.
faIlsafe
Failsafe positions are also set during binding. In
the unlikely event that the radio link is lost during
use, the receiver will drive the servos to their
preprogrammed failsafe positions (normally full
brakes and straight steering). If the receiver is turned
on prior to turning on the transmitter, the receiver
will enter the failsafe mode, driving the servos to
their preset failsafe positions. When the transmitter
is turned on, normal control is resumed. Failsafe
servo positions are set during binding (see Bind on
the previous page).