Owner's manual

Compatible Module Replacement Case Instructions

1. Remove the four screws in the back of the

old case using the included 5/64-inch hex wrench. 2. Remove the back case half.

3. Remove circuit board from the bottom case.

5. Connect the antenna of the new case top to the circuit board. Align the antenna with the connector on the circuit

board. Apply a light pressure to the top of the antenna connector and it will pop into place.

WARNING: Do not force the connector or it could be damaged.

6. Swivel the antenna connector back and forth. If connected correctly, the antenna will swivel freely. If it doesn’t, the

antenna is not connected correctly. If the antenna is not connected correctly, remove the antenna and inspect the

connectors for damage. If you think they are damaged, please contact product support (contact information is listed

at the end of the manual).

4. Remove the antenna wire by lifting up on it

close to where it connects to the circuit board.

New case top

PAGE 1
JR® Compatible Module Replacement Case Instructions 1. Remove the four screws in the back of the old case using the included 5/64-inch hex wrench. 3. Remove circuit board from the bottom case. 2. Remove the back case half. 4. Remove the antenna wire by lifting up on it close to where it connects to the circuit board. 5. Connect the antenna of the new case top to the circuit board. Align the antenna with the connector on the circuit board.
PAGE 2
7. Place circuit board in the new case bottom. Be sure the white connector is aligned over the holes in the case bottom. 8. Set the circuit board in place. white connector holes in case bottom 9. Set the bind button onto the blue button. 10. Put four screws in case bottom and screw case back together. WARNING: Be sure the antenna wire is not crimped between the cases. Do not over-tighten the screws or the case could be damaged. 11. Press the bind button to be sure it operates freely.