Manual

EN
Binding the Telemetry Module and Receiver
1. Using the Bind Stylus press and hold the bind button on the side of the TM1000 telemetry module.
2. While depressing the bind button, power the receiver. The main receiver, all attached remote
receivers and the TM1000 telemetry module should blink indicating the system is in bind mode.
3. With the stick and switches in the desired failsafe positions (normally low throttle and neutral
sticks), put the transmitter into bind mode.
4. The main screen displays the receiver type. After several seconds, the system connects and reverts
to the main screen.
5. From the main screen rotate the roller to access the telemetry screens and verify the flight log data
and receiver voltage displays.