User Manual

BINDING AND PROGRAMMING FAILSAFE

Failsafe is conﬁgured when the transmitter and receiver go through the

binding process. When binding an aircraft, always follow these steps to ensure

the failsafe operates as expected in the unlikely event of a loss of radio link:

1. Move the throttle to the low or off position.

2. Set all other controls to the desired failsafe position.

3. Follow the receiver instructions to power the receiver on in bind mode.

4. From the iX12 transmitter Bind menu, touch and hold BIND until the

transmitter reports it is binding.

5. When the transmitter indicates binding was successful, power off the

receiver, according to the receiver instructions.

After the transmitter and receiver are bound, if the radio signal link is ever

lost between the transmitter and receiver, the receiver immediately moves the

aircraft control surfaces to the failsafe positions or holds position depending

on the type of failsafe set during bind.

TOC