User Manual
Table Of Contents
- How To Use the Manual
- Box Contents
- Basic Operation
- Transmitter Functions
- Spektrum LED
- Charging
- Physical Transmitter Adjustments
- Android Operating System
- Spektrum AirWare Navigation
- Model Type Defaults
- Model Utilities
- Model Details
- Binding
- Auto Switch Select
- Active Boxes
- My List
- Model Adjust
- Servo Setup
- Dual Rates and Expo
- Throttle Cut
- Throttle Curve
- Video Tx
- Mixing
- Sailplane Pre-Configured Mixes
- Forward Programming
- Sequencer
- AS3X®
- Differential
- V-Tail Differential
- Flap System
- Pitch Curve
- Swashplate
- Gyro
- Governor
- Tail Curve
- Camber Preset
- Camber System
- Model Setup
- Bind
- Timers
- Frame Rate
- Spektrum Telemetry
- Analog Switch Setup
- Sleep Mode
- Digital Switch Setup
- Audio Events
- Adjusting Touch Switch Sensitivity
- Channel Assign
- Trainer
- Range Test
- Model Start Warnings
- Serial Port Setup
- Aircraft Type
- Flight Mode Setup
- Trim Setup
- Menu Setup
- System Settings
- System Configuration
- Product Information
- Calibration
- Regulatory Information
- Troubleshooting Guide
- FAQs
- 1-Year Limited Warranty
- Warranty and Service Contact Information
- FCC Information
- IC Information
- Compliance Information for the European Union
- Instructions for disposal of WEEE by users in the European Union
CAMBER SYSTEM PROGRAMMING
To program the Camber System:
1. Congure all of the ight modes before beginning the camber system programming.
2. Touch Camber System from the
Model Adjust menu.
3. Select the ight mode to program. Moving
the ight mode switch changes the ight
mode indicated at the top of the menu.
4. Select an Input for the selected ight mode.
5. Set an Offset value if desired. Offset may be required to compensate for the geometry of
sailplane ap servos.