User Manual
Table Of Contents
- How To Use the Manual
- Box Contents
- Basic Operation
- Transmitter Functions
- Spektrum LED
- Charging
- Physical Transmitter Adjustments
- Android Operating System
- Spektrum AirWare Navigation
- Model Type Defaults
- Model Utilities
- Model Details
- Binding
- Auto Switch Select
- Active Boxes
- My List
- Model Adjust
- Servo Setup
- Dual Rates and Expo
- Throttle Cut
- Throttle Curve
- Video Tx
- Mixing
- Sailplane Pre-Configured Mixes
- Forward Programming
- Sequencer
- AS3X®
- Differential
- V-Tail Differential
- Flap System
- Pitch Curve
- Swashplate
- Gyro
- Governor
- Tail Curve
- Camber Preset
- Camber System
- Model Setup
- Bind
- Timers
- Frame Rate
- Spektrum Telemetry
- Analog Switch Setup
- Sleep Mode
- Digital Switch Setup
- Audio Events
- Adjusting Touch Switch Sensitivity
- Channel Assign
- Trainer
- Range Test
- Model Start Warnings
- Serial Port Setup
- Aircraft Type
- Flight Mode Setup
- Trim Setup
- Menu Setup
- System Settings
- System Configuration
- Product Information
- Calibration
- Regulatory Information
- Troubleshooting Guide
- FAQs
- 1-Year Limited Warranty
- Warranty and Service Contact Information
- FCC Information
- IC Information
- Compliance Information for the European Union
- Instructions for disposal of WEEE by users in the European Union
INSTRUCTOR TRANSMITTER CONFIGURATION
1. Select the type of trainer mode for the application (Wired or Wireless, Programmable
Instructor or Pilot Link Instructor).
2. Choose whether or not to enable Instructor Over-Ride. This setting denes how the
instructor can resume control from the student. When enabled, the instructor must not move
the sticks when the student is given control. Moving the sticks or moving the selected trainer
switch will return control to the instructor.
With Instructor Over-Ride disabled, the switch position determines who is in control.
When Switch I or the right or left trim button is selected, Instructor Over-Ride is disabled by
default. When any other switch is selected, Instructor Over-Ride is enabled.
3. If Wireless Trainer mode was selected in step 1, Bind the student transmitter to the instructor
transmitter. See the Binding Wireless Trainer section.
4. Determine which channels to assign to the student when given control by moving the on-
screen switch for each channel. Students can be given control of a single channel or all
channels, as the instructor sees t.
TOC