User Manual
Table Of Contents
- How To Use the Manual
- Box Contents
- Basic Operation
- Transmitter Functions
- Spektrum LED
- Charging
- Physical Transmitter Adjustments
- Android Operating System
- Spektrum AirWare Navigation
- Model Type Defaults
- Model Utilities
- Model Details
- Binding
- Auto Switch Select
- Active Boxes
- My List
- Model Adjust
- Servo Setup
- Dual Rates and Expo
- Throttle Cut
- Throttle Curve
- Video Tx
- Mixing
- Sailplane Pre-Configured Mixes
- Forward Programming
- Sequencer
- AS3X®
- Differential
- V-Tail Differential
- Flap System
- Pitch Curve
- Swashplate
- Gyro
- Governor
- Tail Curve
- Camber Preset
- Camber System
- Model Setup
- Bind
- Timers
- Frame Rate
- Spektrum Telemetry
- Analog Switch Setup
- Sleep Mode
- Digital Switch Setup
- Audio Events
- Adjusting Touch Switch Sensitivity
- Channel Assign
- Trainer
- Range Test
- Model Start Warnings
- Serial Port Setup
- Aircraft Type
- Flight Mode Setup
- Trim Setup
- Menu Setup
- System Settings
- System Configuration
- Product Information
- Calibration
- Regulatory Information
- Troubleshooting Guide
- FAQs
- 1-Year Limited Warranty
- Warranty and Service Contact Information
- FCC Information
- IC Information
- Compliance Information for the European Union
- Instructions for disposal of WEEE by users in the European Union
RECEIVER INSTALLATION
Always install receivers where the antennas are placed as far possible from metal, batteries,
wires, fuel tanks and other objects. Receivers with integrated telemetry should be installed with a
focus on the antennas attached to the main part of the receiver in an optimal location, as this will
be the only antenna transmitting telemetry information.
Remote receivers should be installed as far from the main receiver as is practical, with the
antennas oriented 90˚ to the main receiver antenna.
Telemetry data can help diagnose receiver signal problems where the receiver is experiencing
signal loss.
TOC