Instruction Manual

36 SPEKTRUM NX20 • TRANSMITTER INSTRUCTION MANUAL
EN
For compatible video transmitters, this menu can select the options
directly from your NX20. Set the Power level and frequency of your
video transmitter, and select Send to make the change.
Switch Changes
Use the switch change report to call out what your switch positions
are. With this menu you can assign audio reports for events such
as changing modes or rates, retract position, flap position, etc.
Stepping Reports
Stepping reports let you select from a list of reports to announce
at each flip of a switch. Stepping reports move to the next report at
every flip of the switch.
Generic Reports
Select Report At Power-Up and check off your desired switches to
get a switch position report of those switches when you power ON
the transmitter.
Center Tone
This menu gives you the ability to add a tone at the center of each
stick travel.
Flight Modes
Choose your audio reports to go with each flight mode in this menu.
Telemetry Warnings
Shortcut to the Telemetry Warnings screen.
Trainer Alerts
This menu gives the user the setup the type of audio alerts with trainer.
Model Start
This menu gives you options for tones and voice for when your
model starts operation, based on throttle or a switch of your choice.
System Sounds
Gives you control over the inactivity alarm and the low voltage alarm
Binding
Gives you control over the audio events during the bind process.
For compatible video transmitters, this menu can select the options
directly from your NX20. Set the power level and frequency of your
video transmitter, and select SEND to make the change.
VTX Setup
Audio Events
Function Bar
Ticker Tape Setup
The screen can display up to 10 features on the bar.
Each slot can be configured to hold:
• A telemetry sensor report
• The position of an input switch
Sensor Configuration
Pick the sensors you want to display from the list of sensors in the
active telemetry list. After selecting a sensor, configure the data to
display to suit your needs.
Field
Select the input you want to have displayed, and the amount of
time it should be shown.
The Function Bar on the NX20 offers 2 features, a Ticker Tape to
show telemetry values and My List which allows quick access to
menu items chosen that are frequently used.
When the NX20 transmitter is showing the normal display (home
screen), the system shows the telemetry scrolling across the
bottom of the screen.
Select Function Bar on the Function List to access the setup
screen. Select the Ticker Tape Setup or the My List Setup for
configuration.