The Leader in Spread Spectrum Technology 2-Channel DSM Stick Surface Transmitter 2 Kanal DSM Stick Surface Fernsteuersender 2 voies Emetteur de surface DSM à manches Trasmettitore 2 canali a stick per auto e scafi Sistema DSM
NOTICE: All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-todate product literature, visit http://www.horizonhobby.com and click on the support tab for this product.
FCC Information.............................................. 12 Compliance Information for the European Union......................................... 12 Declaration of Conformity............................... 13 Instructions for Disposal of WEEE by Users in the European Union.....................
Receiver Compatibility Low Battery Alarm The DX2M is compatible with all current Spektrum™ DSM, DSM2 and marine surface receivers. When the battery voltage drops below 4.7 volts, an alarm sounds and the voltage LEDs flash. The batteries must be replaced immediately. Installing the Transmitter Batteries Binding The DX2M requires 4 AA alkaline, heavy-duty or rechargeable batteries. You must bind the receiver to the transmitter before operating.
MR200 shown above using an electronic speed controller 2. Power up the receiver. If using an electronic speed controller, plug the lead into the throttle port and turn on the switch. If using a receiver pack, plug the battery lead into any open port noting the polarity. The LED on the receiver will begin flashing. SR300 shown above using an ESC and a Dynamite® Speedpack™ 3. Move the sticks on the transmitter to the desired failsafe positions.
4. Press and hold the bind button on the top of the transmitter while turning on the power switch. Release the bind button once the LEDs on the front of the transmitter flash and you hear a series of beeps. Within a few seconds the system should connect. Once connected, the LED on the receiver will go solid indicating the system is connected. CAUTION: Continuing to hold the bind button during the binding process prevents preset failsafe positions from being learned by the receiver.
STEERING TRIM STEERING Rate The steering trim slider adjust the steering trim when the wheel is centered. Move the slider left or right to change the steering trim (the steering at rest position). Normally steering trim is adjusted until the car tracks straight. Steering rate (also known as dual rate) allows you to make on-the-fly steering travel adjustments using the steering rate dial. Steering rate limits the amount of travel of the steering servo.
Throttle 50/50, 70/30 Switch The DX2M features a two-position throttle stick that adjusts the ratio of travel forward and backward. It can be either 50/50 or 70/30. The 50/ 50 throttle position offers symmetrical stick travel in both forward and backward directions. This is commonly used for boats that have proportional forward and proportional reverse control. The 70/30 throttle position provides a larger 70% forward stroke, offering more precise forward control for boats that use forward only.
Safety Points to Obey for Modelers • Ensure your batteries (both transmitter and receiver) have been properly charged for your model. • Keep track of the time the system is turned on so you will know how long you can safely operate your DX2M. • Check all servos and their connections prior to each run. • Do not operate your model near spectators, parking areas or any other area that could result in injury to people or damage of property. • Do not operate your model during adverse weather conditions.
Warranty and repair policy Warranty Period Exclusive Warranty- Horizon Hobby, Inc., (Horizon) warranties that the Products purchased (the “Product”) will be free from defects in materials and workmanship for a period of 1 (one) year from the date of purchase by the Purchaser. 1 Year Limited Warranty Horizon reserves the right to change or modify this warranty without notice and disclaims all other warranties, express or implied.
Warranty Services Questions, Assistance and Repairs Notice: Do not ship batteries to Horizon. If you have any issue with a battery, please contact the appropriate Horizon Product Support Department. Your local hobby store and/or place of purchase cannot provide warranty support or repair. Once assembly, setup or use of the Product has been started, you must contact Horizon directly. This will enable Horizon to better answer your questions and service you in the event that you may need any assistance.
FCC Information This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Declaration of Conformity (in accordance with ISO/IEC 17050-1) No.
® ® www.horizonhobby.com www.spektrumrc.com Printed 12/10 The Spektrum trademark is used with permission of Bachmann Industries, Inc. All other marks are trademarks or registered trademarks of Horizon Hobby, Inc. US patent 7,391,320. Other patents pending. SPMR2200 29069.
