Spektrum Firma 70A Brushed Smart ESC Spektrum Firma 70A Brushed Smart Regler Spektrum Firma 70A Contrôleur à balais Smart Spektrum Firma 70A Smart Brushed ESC
SPMXSE1070 Scan the QR code and select the Manuals and Support quick links from the product page for the most up-to-date manual information. Scannen Sie den QR-Code und wählen Sie auf der Produktseite die Quicklinks Handbücher und Unterstützung, um die aktuellsten Informationen zu Handbücher. Scannez le code QR et sélectionnez les liens rapides Manuals and Support sur la page du produit pour obtenir les informations les plus récentes sur le manuel.
NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit horizonhobby.com or towerhobbies.com and click on the support or resources tab for this product.
way without the approval of Horizon Hobby, LLC. This manual contains instructions for safety, operation and maintenance. It is essential to read and follow all the instructions and warnings in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or serious injury. Age Recommendation: Not for children under 14 years. This is not a toy. NOTICE: This product is only intended for use with unmanned, hobby-grade, remote-controlled vehicles and aircraft.
CAUTION: Failure to exercise caution while using this product and comply with the following precautions could result in product malfunction and/or void the warranty. GENERAL PRECAUTIONS • Read through the wet conditions maintenance procedures and make sure that you have all the tools you will need to properly maintain your ESC. • Do not operate your ESC where it could come in contact with salt water (ocean water or water on salt-covered roads), contaminated or polluted water.
ing water, or frequent, intermittent immersion of waterproof component(s). • 1 hour continuous operation in damp sand, dirt, mud or snow (the material level should always be below the vehicle frame), constant splatter without any immersion or coverage of waterproof component(s). Furthermore, when appropriate maintenance procedures (as described below) are performed promptly following exposure, the ESC will remain best protected from corrosion or other long-term, water-related damage.
Contents Waterproof Component........................................................ 4 General Precautions........................................................... 5 Usage Conditions............................................................... 5 Wet Conditions Maintenance............................................... 6 System Specifications.......................................................... 8 Wiring Diagram.................................................................... 9 Installation......
System Specifications Type Constant/Peak Function Programming Port Auxiliary Power Outputs Vehicle Type Optional Features Battery Type/Input Voltage Recommended Motor Type Compatible Motors (Based on Battery Voltage) BEC Output 8 Dimensions Weight Battery Connector Motor Connector Brushed 70A/200A Forward/Reverse; Forward/Brake/ Reverse, Forward/Brake (Can be programmed via SPMXCA200 or through the push button on the switch) Optional Programming Box (2) Standard Female Servo Connectors for Lights, etc @
Wiring Diagram Auxiliary (Light) Connectors Programming Port Heatsink Power Programming Button Bullet Connectors Between ESC and Motor Throttle Connector to Receiver LED IC3 Power Input Connector NOTICE: Always disconnect the battery from the ESC when you have finished operating your vehicle.
Installation 1. Determine how to mount the ESC as specified by your vehicle’s instruction manual, or in an area with adequate airflow and protection from damage. Ensure all wiring connections can be reached prior to mounting. 2. Use double-sided foam tape or the mounting tabs with screws on the bottom of the case to secure the ESC in position. The switch can be mounted with double sided foam tape. 3.
3. Press and hold the programming button on the switch case, power on the ESC. The red LED on the ESC will flash, and the motor will beep. Release the programming button. The ESC will enter the programming mode if the programming button is not released within 3 seconds. 4. With the throttle trigger and trim in the neutral position, press and release the programming button. The red LED will flash once, and the motor will emit 1 tone. 5. Pull the throttle trigger to full throttle.
ESC Programming via Switch Push Button 1. Power ON your transmitter. Connect a battery to the ESC and power it ON. NOTICE: The transmitter and receiver must be connected. 2. Press and hold the programming button for 1 second. OPTIONAL: Press and hold the programming button for 5 seconds to reset all ESC programming options. 3. Release the programming button. The red LED will blink to indicate it has entered programming mode 4. The red LED blinks (and the motor beeps) to indicate the programming item.
Programming the ESC via the SPMXCA200 Program Box 1. Begin with no battery connected. 2. Connect the cable for the programming box into the programming port as shown. 3. Connect a battery and power ON the ESC. OPTIONAL: The ESC settings can be reset to default by pressing “Reset” and then “OK” buttons. 4. Press Select button on the program box once. 5. Select the programming choices. Press SAVE after any changes are made. 6. Power off the ESC. 7. Disconnect the cable for the programming box.
Programmable Features 1. Running Mode 2. Lipo Battery 3. Cutoff Voltage 4. Initial Start Force (%) 5. Max Forward Force (%) 6. Max Reverse Force (%) 7. Max Brake Force (%) 8. Initial Brake Force (%) 9. Drag Brake (%) 10. Drag Brake Rate (Level) 11. Neutral Range (%) 12. Start Mode / Punch (Level) 13. PWM Frequency 14.
1 Fwd/Brk ON Disabled 0 25 25 0 0 0 1 3 1 1K 6.0V 2 Fwd/Rev/Brk OFF Auto (Low) 2 50 50 12.5 6.25 5 2 4 2 2K 7.4V Auto (Med) 4 75 75 25 12.50 10 3 5 3 4K 3 Fwd/Rev Auto (High) 6 100 100 37.5 18.75 50 4 6 4 8K 4 Blacked out cells with white text represent the default settings. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Programmable Values 10 62.5 31.25 70 6 8 6 50 25 60 5 7 5 16K 6 8 5 75 37.50 80 7 9 7 12 7 87.5 43.
LED Indicator and Motor Sounds Upon powering on the ESC, the LED will blink and the motor will emit a series of beeps to indicate its status. First it will display the battery mode selection, second the drag brake setting, and then it will indicate it is ready to operate.
Troubleshooting Guide Problem ESC ON – No motor function, audible tone or LED Possible Cause Battery/connection issue Damaged ESC/ switch Damaged motor Low voltage protection Motor – Stops and LED blinks Overheat protection Battery issue Motor – AccelerIncorrect gearing ates irregularly Worn or damaged motor Motor – Does not turn continuously ESC/motor in response to damaged throttle Motor – Slows but will not stop Incorrect transmitter/ESC calibration Solution Recharge/replace battery.
Troubleshooting Guide Problem Possible Cause Damaged motor Steering Servo – Operates; motor does not run Incorrect transmitter/ESC calibration Low battery voltage Solution Test the motor apart from the vehicle system, repair/replace motor as needed Adjust throttle travel/ other throttle settings on the transmitter/ ESC.
1-Year Limited Warranty What this Warranty Covers – Horizon Hobby, LLC, (Horizon) warrants to the original purchaser that the product purchased (the “Product”) will be free from defects in materials and workmanship for a period of 1 year from the date of purchase.
LOSS OF PROFITS OR PRODUCTION OR COMMERCIAL LOSS IN ANY WAY, REGARDLESS OF WHETHER SUCH CLAIM IS BASED IN CONTRACT, WARRANTY, TORT, NEGLIGENCE, STRICT LIABILITY OR ANY OTHER THEORY OF LIABILITY, EVEN IF HORIZON HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Further, in no event shall the liability of Horizon exceed the individual price of the Product on which liability is asserted.
a Return Merchandise Authorization (RMA) number. Pack the Product securely using a shipping carton. Please note that original boxes may be included, but are not designed to withstand the rigors of shipping without additional protection. Ship via a carrier that provides tracking and insurance for lost or damaged parcels, as Horizon is not responsible for merchandise until it arrives and is accepted at our facility. An Online Service Request is available at http://www.horizonhobby.
Non-warranty service estimates will be billed a minimum of ½ hour of labor. In addition you will be billed for return freight. Horizon accepts money orders and cashier’s checks, as well as Visa, MasterCard, American Express, and Discover cards. By submitting any item to Horizon for service, you are agreeing to Horizon’s Terms and Conditions found on our website http://www.horizonhobby. com/content/service-center_render-service-center.
FCC Information SUPPLIER’S DECLARATION OF CONFORMITY Firma 70A Brushed Crawler Smart ESC (SPMXSE1070): This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Horizon Hobby, LLC 2904 Research Rd.
Compliance Information for the European Union EU COMPLIANCE STATEMENT Firma 70A Brushed Crawler Smart ESC (SPMXSE1070): Hereby, Horizon Hobby, LLC declares that the device is in compliance with the following: 2014/30/EU EMC Directive; RoHS 2 Directive 2011/65/EU; RoHS 3 Directive Amending 2011/65/EU Annex II 2015/863. The full text of the EU declaration of conformity is available at the following internet address: https://www.horizonhobby.com/ content/support-render-compliance.
96 © 2022 Horizon Hobby, LLC. Firma, the Firma Logo, IC3, EC3, DSM2, DSMR, the Smart Technology logo, and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc. All other trademarks, service marks and logos are property of their respective owners. US 9,930,567. US 10,419,970. SPMXSE1070 Updated 04/2022 205653.
