Firma 70A Brushed Smart ESC Manual
11
Operation
1.
Power on the transmitter.
2.
Power on the receiver.
3.
Disconnect the battery from the ESC after operation.
3.
Press and hold the programming button on the switch case,
power on the ESC.
The red LED on the ESC will flash, and the motor will beep.
Release the programming button.
The ESC will enter the programming mode if the programming
button is not released within 3 seconds.
4.
With the throttle trigger and trim in the neutral position, press
and release the programming button. The red LED will flash
once, and the motor will emit 1 tone.
5.
Pull the throttle trigger to full throttle. Press and release the
programming button. The red LED will flash twice, and the
motor will emit 2 tones.
6.
Push the throttle trigger to full reverse. Press and release the
programming button. The red LED will flash 3 times, and the
motor will emit 3 tones.
7.
Power OFF the system with the ON/OFF switch.
8.
Power ON the system with the ON/OFF switch. The system is
ready for operation
TIP: Beeps from the motor may be quiet and difficult to hear,
use the LED status to help verify settings.