User Manual

LED Indicator

LED Indicator LED Code

ESC turned On, LED indicator is Off Throttle trigger is in the neutral zone

Red LED illuminated ESC is operating in forward, reverse or brake

Red and Green LED illuminated

ESC is at full throttle, full brake, or full reverese

LED ﬂ ashes red with short single pulses LVC protection activated

LED ﬂ ashes green with short single pulses The ESC is in thermal shutoff mode

LED ﬂ ashes green with three short pulses repeating

The ESC has exceeded the continuous current limit

LED ﬂ ashes green with four short pulses repeating

The ESC has failed the self test

LED ﬂ ashes green with ﬁ ve short pulses repeating

Capacitor temp has been exceeded

Programming with the SPMXCA200 Smart Programmer Box

1. Unplug the fan and connect the programming lead to the fan port.

2. Connect a battery to the ESC.

3. Power on the box and select the parameter with the SELECT button.

4. Change the values of the selected parameter with the EDIT button

5. Press the SAVE button to save the changes. The ESC requires a power cycle

to implement the saved changes.

Operation

1. Connect a battery to the ESC.

2. Leave the transmitter throttle at neutral and press the On/Off button on the

ESC to turn it on. The ESC will cause the motor to make several tones.

The number of tones indicates (1) the ESC is in operation (2) the LiPo cell

count detected and (3) the ESC is in a ready-to-use state.

3. Press the On/Off button or unplug the battery to turn off the ESC.

NOTICE: Do not leave a battery connected with the ESC turned off for extended

periods of time. Always unplug the battery for storage or the battery may be damaged.