Instructions

20
ASSEMBLY
Installation instructions
The mounting plate can be rotated by 180° if so required by the installation conditions. It is not necessary to
disassemble the components already installed on the mounting plate. The plate can be loosened and rotated
together with all assembled elements. In order to do this, the four fixing points must be loosened.
For this purpose, remove sealing plugs of the fixing
points by prizing them off and loosen the M4 nut
underneath. Now the insulation caps can be
removed.
The mounting plate can then be lifted and turned
by 180°.
After this, put the insulation caps back on, tighten
the M4 nuts with 1 Nm torque and place the sealing
plugs back in place.
Now the housing openings must be adapted to the
new position and closed with cable gland (6 Nm) or
locking screws (2 Nm).