I/R Thermometer Gun 12:1 800103 INSTRUCTION MANUAL SPER SCIENTIFIC
Contents Page 1. Introduction ................................................... 2 2. Safety Information ......................................... 3 3. Display And Button Locations ....................... 4-5 4. Distance to Spot ........................................... 5 5. Measuring Procedures ................................. 6 6. Battery Replacement .................................... 6 7. Cleaning........................................................ 7 8. Specifications ........................
2. SAFETY INFORMATION Read the following safety information carefully before attempting to operate or service the IR Gun. Only qualified technicians should perform repairs. • DO NOT submerge the IR Gun in water. • Protect the IR Gun from water, shock, dust, and extreme environments. • The IR Gun may be used to measure body temperature simply for reference. This unit is not intended for medical evaluations. • Dispose of properly. • Contains a laser pointer. Keep away from children.
3. DISPLAY AND BUTTON LOCATIONS 1 2 3 4 ON 5 6 1. Laser Guide 7 2. IR Sensor 3. Trigger 4. °C/°F Selector 5. Laser On/Off Selector 6. Battery 7.
8 SCAN °C HOLD °F 9 10 11 12 193.5 13 8. Low Battery Indicator 11. °C & °F 9. Laser Guide On/Off 12. Hold 10. Scan 13. Temperature Reading 4. Distance-to-Spot The distance-to-spot ratio is 12:1. As the distance from the object increases, the spot size of the area measured by the gun also increases.
5. MEASURING PROCEDURES See page 4-5 for display and button locations. For best results, allow the thermometer to adjust to the ambient temperature for 30 minutes before use. For accurate readings, the IR lens must be clean (pg 7). • Slide the Laser ON/OFF Selector (5) to turn the Laser Guide (1) on or off. • Slide the °C/°F Selector (4) to switch temperature units. • Point the IR Gun at the object to be measured.
. CLEANING To obtain accurate readings, the lens must be clean. Clean the lens with compressed air, soft brush, or a moist cotton swab. Do not use solvents on the lens. Clean the case with mild soap on a cloth or sponge. 8. SPECIFICATIONS D:S Ratio Range 12:1 -32~535°C (-25~999°F) Resolution 0.1°C/F ±3°C (±5°F) From -32~-20°C (-25~-4°F) Accuracy ±2°C (±3°F) From -20~100°C (-4~212°F) ±2% From 100~535°C (212~999°F) Thermophile 5~14µm Dim (approx.
Conforms to the following standards: • EN61326: Electrical equipment for measurement, control and laboratory use. • IEC61000-4-2: Electrostatic discharge immunity. • IEC61000-4-3: Radiated, radio-frequency, electro-magnetic field immunity test. • IEC61000-4-8: Power frequency magnetic field immunity test. • CFR 1040.10 subchapter J Class II Laser Product Tests were conducted using a frequency range of 80~1000MHz with the unit in three orientations. The average error is ±0.5°C (±1.
