How-To Guide

Connecting to your Trimlight System
Your Trimlight system will be broadcasting a Wi-Fi signal. This signal does not have any internet capabilities. This Wi-Fi signal
will only be used to control your Trimlight system. If using a smartphone or tablet that is not for sole use of this system, we
suggest pairing the controller to your wireless network. Refer to the steps below for more information on pairing.
Step #1
Ensure the BLUE light on the controller is
illuminated. This light is located near the
V+ and V– terminals. Push the AP/STA
Button on the controller to change from
the GREEN light to the BLUE light.
Step #2
Go to the settings on the Smartphone or
Tablet and search for the broadcasting signal
TrimlightA. If a password is requested enter
12345678. Once connected there will be no
internet usage while connected to this signal
from your device.
Step #3
Drag your finger down on the settings
page to refresh available controllers.
Step #4
Once connected, Ensure the controller is
set for the correct settings. These settings
are highlighted below.
Step #5
With correct settings, ensure the device isturned
ON withthe toggle switch andenter the device by
selecting ENTER on the bottom of the screen.
ON/OFF
List of Controllers
This area will list all controllers that are
available and connected. This could
include controllers that are for separate
buildings, back patios, downlighting,
ridgelighting, etc.
To change the name of the controller,
Push and hold on the wording to change
the name.
Enter
Use this button to enter into the system
to choose colors, patterns, access your
calendar and timing functions.
Settings
ON/OFF for each controller
Ensure that all settings are correctly
chosen to ensure the system is working
properly.
RGB ORDER: RGB
IC: UCS1903
TOTAL PIXELS: This amount is dependent
on how many pixels are on the longest run
of the system. Consult with your installer
to confirm the amount of lights that are
on your system.
Pairing to a Wifi Network
To connect the Trimlight controllers to a local Wifi network. Ensure there is strong Wifi signal to where the controller is located.
Weak signals may require a Wifi signal booster, available at any electronics retailer. Once this process has been completed, the
user will no longer need to use the Trimlight wifi signal to connect to the controllers. Follow these steps for connecting:
STA/AP Button Green Light Indicator
Step #1
Ensure the device is connected to the
local Wifi network.
Step #3
Open the app to the device menu section
and push “+Add Device”
Step #2
Push and Hold on the STA/AP button on the Trimlight
Controller until a green light flashes on the unit.
Step #4
The App will prompt the user to enter the
wifi network password. Enter the password
and press enter.
Step #5
The system may take several minutes to
configure. Once configured properly, the
flashing green light will turn solid.