User's Manual
Table Of Contents
- YHO-PXT51012_FCCID_Usermanual.pdf
- FCC Warning.pdf
- _
- FCC Warning
- _
- This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- _
- NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- - Reorient or relocate the receiving antenna.
- - Increase the separation between the equipment and receiver.
- -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- -Consult the dealer or an experienced radio/TV technician for help.
- _
- NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
- _
19
2. Installation
Brancher l'adaptateur secteur à l’arrière de l'appareil. Raccorder ensuite l'adaptateur sur la prise
secteur.
Pour mettre en route le cadre, appuyer sur le bouton situé à l’arrière du cadre. L'appareil démarre,
au bout de 2 secondes, l'écran s'allume, il est opérationnel au bout de 30 secondes environ.
3. Présentation de l'interface principale
Environ 30 secondes après la mise en route de l'appareil, votre Pix-Star affiche le menu principal.
Puis au bout de 20 secondes environ le diaporama démarre automatiquement.
En utilisant les boutons situés à l'arrière de l'appareil, vous pouvez naviguer à l'intérieur des menus.
Pour ouvrir le MENU principal, appuyer sur le bouton « menu ». Pour entrer dans le sous-menu
souhaité presser la touche " ".
Pour quitter le mode diaporama et revenir au menu principal, utiliser la télécommande et
appuyer sur la touche
ou deux fois sur la touche MENU.
Remarque : A tout moment, appuyer sur la touche pour revenir au menu précédent.