User's Manual
Table Of Contents
- YHO-PXT51012_FCCID_Usermanual.pdf
- FCC Warning.pdf
- _
- FCC Warning
- _
- This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- _
- NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- - Reorient or relocate the receiving antenna.
- - Increase the separation between the equipment and receiver.
- -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- -Consult the dealer or an experienced radio/TV technician for help.
- _
- NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
- _
4
2. Installation and Power On
First, plug the AC adapter at the back of the device, then plug the AC adapter to a power
outlet/socket.
To turn on the device, move the switch button located on back/bottom side of the device next to
the AC adapter plug. After a few seconds, the screen should display a logo.
Wait for about 30 seconds for the device to be ready for use.
3. Introduction to the Main User Interface
After you power on the device and wait for approximately 30 seconds your Pix-Star will display the
main menu.
You can navigate the menus using the remote control or the buttons located behind the device on
the right side.
When the slide show is playing, to quit the slide show and go back to the main menu press the Back
button or the Menu button twice.
When the main menu is displaying on the Pix-star’s screen, select the menu you want to enter using
the UP and DOWN buttons then press the / OK button to enter it.
Note: The Back
button on the remote control allows you to go back to the previous menu (upper
level menu)