User Manual Part 1

HDE 01/2016
15
NOTICE
This device complies with Part 15 of the FCC Rules [and with Industry Canada licence-exempt RSS
standard(s)].
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
5.6 Maintenance
instruction
To ensure performance in accordance with this document, the following routine
maintenance checks should be undertaken at intervals of no more than one
month:
• Inspect and operate the emergency exit device in order to ensure that all components
are in a satisfactory working condition.
• The operating forces to release the exit device must be measured and recorded using
a force gauge.
• Ensure that the keeper(s) (strike(s)) is (are) free from obstruction.
• Check that the emergency exit device is lubricated in accordance with the manu-
facturer’s instructions.
• Check that no additional locking devices have been added to the door since its
original installation.
• Check periodically that all components of the system are still correct in accordance
with the list of approved components originally supplied with the system.
• Check periodically that the operating element is correctly tightened and, using a force
gauge, measure the operating forces to release the exit device. Check that the
operating forces have not changed significantly from the operating forces recorded
when originally installed.
6. Approval according to Part 15 of the FCC rules
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a par-
ticular installation. If this equipment does cause harmful interference to radio or televisi-
on reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
NOTICE
Changes or modifications made to this equipment not expressly approved by (manufacturer name)
may void the FCC authorization to operate this equipment.
MA_DT710_2015-08-20.book Seite 15 Freitag, 22. Januar 2016 11:15 11