User's Manual

40
Fig. 6: Rear cover
3.
Unscrew and remove rear cover of the terminal (Fig. 6).
Fig. 7: Clamp terminal block at rear of the WT 210
4.>
Connect cables to terminal clamps
Ensure correct polarity of the supply voltage.
Fig. 8: Rear of the WT 210 with cable
5.>
Screw rear cover back to WT 210 (Fig. 8/1). When doing this, lead out the cables sideways at the padded
cable ducts (Fig. 8/2).
6.>
NOTE! Risk of damage to cables!
Carefully slide terminal module and cables into the switch box. Ensure that cables are not jammed.