User's Manual

41
7.>
Push terminal module (LEDs upwards) into the frame until it snaps into the lateral notches of the frame.
Fig. 9 WT 210 with frame
8.>
Restore power supply of WT 210.
4.3 After installation
1.
Connect power supply
2.
Check operation.
The installation has been carried out correctly if the following points apply:
- Red LED shines
Configuration and initial start-up
The system configuration and the configuration of the WT 210 take place via the Dialock
software, and are carried out by the system supplier customer service department.
The initial start-up of the access control system is also carried out by the system supplier
customer service department.
For more information about starting up and configuring the overall system, see Dialock 2.0
user manual.