Users Manual Part 2

29
HDE 11/2018 732.29.128
During the entire operating time of the access control system, the operator must
verify that the operating instructions created correspond to the current state of
the regulations and, if necessary, adapt them.
The operator must clearly regulate and specify the responsibilities for
installation, operation, troubleshooting, maintenance, and cleaning.
The operator must ensure that all persons handling the access control system
have read and understood these instructions. In addition, the operator must
train the personnel at regular intervals and inform them about the risks.
Furthermore, the operator is responsible for ensuring that the access control system
is always in perfect technical condition. The following therefore applies:
The operator must ensure that the maintenance intervals specified in these
instructions are followed.
The operator must have all safety devices inspected regularly for function and
completeness.
2.7 Personnel
requirements
Essential requirements
Only those persons are authorised as personnel who can be expected to carry out
their work reliably.
Persons whose ability to react is affected by, e.g., drugs, alcohol, or medication are
not permitted to operate the system.
In the selection of personnel, observe appropriate training as well as the applicable
occupation-specific regulations.
These instructions describe the qualifications listed below for the personnel for the
various work areas:
Qualified electrician
Qualified electricians are capable of working on electrical systems and recognise
potential hazards and avoid them due to their professional training, knowledge,
experience as well as knowledge of pertinent standards and provisions.
Qualified electricians have been specifically trained for the working environment in
which they operate and know the relevant standards and regulations.
Installation and start-up personnel
Installation and initial start-up may only be carried out by trained experts. Knowledge
of the following is a prerequisite:
National accident prevention regulations
National fire prevention regulations
Expert electro-technical knowledge
If the installation and start-up personnel do not have these qualifications, a specialist
installation company must be commissioned to do the work.
Personnel who are being trained may only install and start up the product under
supervision or after being authorised to do so by someone with experience.
The operator and the installer are personally responsible for compliance with the
VDE regulations (and the national electrotechnical and electronics regulations).
ins-src-732.29.128.book Seite 29 Dienstag, 20. November 2018 10:27 10