Installation Instruction Manual

Spicer
®
Axles & Brakes
FOAM INSERT INSTALLATION:
The foam in
serts are designed to eliminate contamination
from the bushing area. Foam inserts must be installed
between the knuckle caps and the top of the kingpins.
Foam inserts are used on the top and bottom of both
Knuckles as shown in the illustration.
NOTE: The enclosed Inserts should be installed on
all steer axle models that use them by design, even
if they where not originally installed or used in the past.
P/N: SHAIS151A
November 2003
Printed in U.S.A.
Spicer
®
Axles & Brakes
FOAM INSERT INSTALLATION:
The foam in
serts are designed to eliminate contamination
from the bushing area. Foam inserts must be installed
between the knuckle caps and the top of the kingpins.
Foam inserts are used on the top and bottom of both
Knuckles as shown in the illustration.
NOTE: The enclosed Inserts should be installed on
all steer axle models that use them by design, even
if they where not originally installed or used in the past.
P/N: SHAIS151A
November 2003
Printed in U.S.A.
IMPORTANT!
IMPORTANT!