Service Manual: S110 and S130

Differential Carrier Assembly

Pinion Removal

1. Remove yoke nut.

2. Remove yoke using a yoke puller service tool.

1 - Yoke puller

3. Remove oil seal.

4. Place carrier in a press with

threaded end of pinion

face up.

5. Place a wood block under pinion to avoid damage to

gear teeth.

1 - Press

2 - Outer bearing

3 - Inner bearing

4 - Wood block

5 - Drive pinion

6 - Bearing preload spacer

6. Press pinion through outer bearing and out

of carrier

casting.

7. Remove bearing preload spacer and save for use in

reassembly

8. Remove inner bearing cone from pinion using a

split-type puller

. Use two procedure steps to remove

each bearing.

a. Mount puller vertically to separate the bearing. This

action will for

ce puller halves under bearing and start

moving bearing off pinion.

b. Mount puller horizontally to press pinion out of bear-

ing.

1 - Press

9. If bearings are to be replaced, remove bearing cups

from

carrier casting at this time. Pinion removal

complete.