Service Manual: S110 and S130

Drive Pinion

Pinion Installation

Final Buildup

Note: Do not install oil seal in carrier until bearing preload is

correctly adjusted.

1. Press inner bearing cone on pinion.

To prevent bearing damage, use suitable sleeve that only

cont

acts inner race of bearing cone.

2. Install preselected bearing spacer.

3. Press inner and outer bearing cups into

the carrier

until seated. Use a feeler gage (.0015" [.038 mm]

approx.) to make sure that bearing cups are fully

seated in bearing bores. Apply lubricant to both cup

and cone.

4. Place carrier housing in press with the pinion sup-

ported by wood block (6" x 6" x 6" [152 x 152 x 152

m]), so the inner pinion bearing is mated to the

cone.

1 - Press

2 - Outer pinion bearing

3 - Wood block

4 - Drive pinion

5 - Bearing preload spacer

5. Press outer bearing onto pinion until completely

seated. Rotate carrier during

seating process.

6. Use torque multiplier and torque pinion nut to

5-753 lbs. ft. (847-1021 N•m).

IMPORTANTIMPORTANT