Service Manual: S110 and S130

Wheel Differential Assembly

17. Install and hand-tighten all new ring gear capscrews.

18. The interface of the ring gear to differential case is a

pres

s fit. Put the assembly in a press with the ring

gear facing upward. Make certain that the ring gear

is flush and square to the differential case before

pressing. Press until ring gear bottoms out on the

case.

DO NOT use the capscrews to draw the ring gear into place.

Only use a press.

19. Press new ring gear bearing cone.

When pressing differential case bearing cones, note that

e bearing is beyond flush with the top of the case. The

cone must be fully seated. To prevent bearing damage, use

suitable sleeve that only contacts the inner race of the

cone. A used bearing race would be a suitable tool. This

tool should have a slit cut if the ID is the same as the bear-

ing boss OD.

20. Tighten and torque ring gear c

apscrews in an alter-

nating pattern. 140-160 lbs. ft. (190-217 N•m).

IMPORTANTIMPORTANT