Service Manual: S110 and S130

26
Wheel Differential Assembly
Disassemble, Overhaul, and Assemble Wheel Differential - S130
Disassemble Wheel Differential
1. Remove capscrews fastening ring gear to differential
case.
2. The ring gear to differential case interface is a press
fit. Place the assembly
in a press with the case fac-
ing downward. Support the assembly on eitiher side
of the
ring gear. Thread a capscrew back into one of
the case holes by hand. Press down on the head of
the capscrew, you may need to press in more than
one position to free the ring gear from the case.
Do not press on the wheel differential shaft to free the ring
gea
r from the case. Pressing on the wheel differential shaft
may cause it to bend and/or fatigue.
The differential case and gears will fall after separation.
Suppo
rt the case so that it will not cause damage to the dif-
ferential or bodily injury.
3. Remove the outer side gear.
4. Remove the differential shaft locking pins by turning
the differe
ntial case opening facing down. Use a
hammer to lightly tap on the side of the case to free
the locking pins.
5. The locking pins are slip fit and should fall from the
case easily
.
IMPORTANTIMPORTANT
CAUTIONCAUTION