Service Manual: S110 and S130

Wheel Adjustment

Wheel End

Wheel Ends without Oil Fill Hole

1. With axle level and wheel ends assembled, add lubri-

cant through filler hole in carrier until

fluid is level

with the bottom of filler hole.

2. Raise the right side of the axle six (6) inches (152

) or more. Hold axle in this position for one (1)

minute.

3. Lower the right side.

4. Raise the left side of the axle six (6) inches (152

) or more. Hold axle in this position for one (1)

minute.

5. Lower the left side.

6. With axle on a level surface, add lubricant through

carrier oil filler hole

until fluid is level with the bot-

tom of the hole.

Note: Axles witho

ut wheel end fill holes will require approxi-

mately 2.5 additional pints of lubricant to bring the lube

level

even with the bottom of fill hole.

1 - Oil will run into wheel end

2 - Oil will run into wheel end