Service Manual: S110 and S130

Lubrication

Change Lube

Drain

1. Drain when the lube is at normal operating tempera-

ture (150°-200°F [66°-93°C]). It

will run freely and

minimize the time necessary to fully drain the axle,

this insures the axle is flushed.

2. Remove the bottom two carrier t

o housing cap-

screws and allow the lube to drain into a suitable

cont

ainer.

Note: Dispose

of all used lubricants properly by following dis-

posal methods approved for mineral- or syntheti

c-based

oils.

3. Inspect breather for clogging or corrosion. Clean or

repla

ce as necessary.

Fill

1. Reinstall bottom two carrier to housing capscrews –

use Loctite 270 and torque to 142–158 lbs. ft. (193-

214 N•m).

2. Remove the filler hole plug from the side of the car-

rier and fill the axle with the approved lubricant until

level

with the bottom of the hole.

3. If wheel ends were removed, follow instructions in

the wheel end ser

vicing section.

Always use the filler hole as the final reference. If lube is level

with

the bottom of the hole, the axle is properly filled.

Note: Lube fill capacities are basic guid

elines and will vary

based on the angle the axle is installed in a particular

chassis. Torque fill plug to 40–60 lbs. ft. (54–82 N•m).

TIP: Th

e axle can be filled through the axle housing breather

hole. Fill until lube level is even with the bottom of filler hole in

side of carrier.