User's Manual

•
if the locate small cell feature is active
•
if the follow IMSI feature is active
This table shows the default LED behavior of the USC 8718:
Table 3: Cisco USC 8718 LED Behavior
Flash RateStatusLED
Approximately ½ second on, 1½ sec. offAdministratively disabledGreen: slow flashing
Approximately 1.4 second on/off cycleBootingGreen: fast flashing
OperationalGreen: solid
FaultRed: solid
Approximately 1 second on/off cycleOne or more emergency calls activeRed: fast flashing
Approximately 1 second on/off cycleLocate small cell enabled
1
Blue: fast flashing
Follow IMSI enabled
1
Blue: solid
Powered off or LED disabledOff
1
Refer to the Cisco USC 8000 Series OS Administrator Guide for information about "locate small cell" and "follow IMSI".
To disable the LED display:
1
From the Configuration Mode, use the set System RadioNode LED DefaultMode Dark command.
2
To verify the configuration, use the show System RadioNode LED command.
show System RadioNode LED
DefaultMode Dark;
To re-enable the LED display:
1
From the Configuration Mode, use the set System RadioNode LED DefaultMode Standard command.
2
To verify the configuration, use the show System RadioNode LED command.
show System RadioNode LED
DefaultMode Standard;
Safety Instructions
Translated versions of the following safety warnings are provided in the Regulatory Compliance and Safety Information document
for this product, located on Cisco.com.
11