User's Manual

Table Of Contents

Install Your Small Cell Module

The small cell module can be installed in either a Cisco Aironet 3600 series access point (AP), a Cisco Aironet 3700 series AP or the

Cisco USC 5030 chassis according to these instructions:

Procedure

Step 1

Remove the module from the packaging.

Step 2

Power down the access point if you are installing the small cell module into an operational access point.

Step 3

Peel off the label from the back of the AP to reveal the module port connector.

Figure 2: Backside of Cisco Aironet 3600 Access Point

Openings for module's antennas1

Label covering port connector2

The Cisco 3600 and 3700 APs have one module port connector. The USC 5030 has two module port connectors.Note