User's Manual

Table Of Contents

Because the small cell module is thicker than the AP, you must hold both units together when attaching

them.

Note

Step 6

Screw down the thumb screws on the module.

If the screws are not tightened, the module will not be recognized and may not operate correctly. Make sure not

to over-tighten the screws; they should be only hand-tightened.

Note

Step 7

Power up the access point.

Step 8

If necessary, mount the access point or USC 5030 chassis, with the small cell module installed, using the universal bracket

(AIR-AP-BRACKET-2).

The universal bracket works with electrical boxes, can be used for wall mounting, and adapts to ceiling installations.

It leaves a larger gap between the mounting surface and the access point, which allows space for the small cell

module.

For more information, refer to "Access Point Mounting Instructions" at the following URL:

http://www.cisco.com/en/US/docs/ wireless/access_point/mounting/guide/apmount.html

Note