User's Manual

SmartCloud Radio Node - SCRN 200 Hardware Installation Guide
SpiderCloud Wireless, Inc.
10
Figure 5 shows the valid radio node cabling/powering options:
Figure 5 Valid Radio Node Cabling/Powering Options
SpiderCloud recommends the third-party Phihong POE36U-1AT single-port PoE+ injector. Use this injector
only when a PoE+ Ethernet switch is not available.
Figure 6 Phihong POE36U-1AT PoE+ Injector
To connect the PoE+ injector to a radio node
Step 1 Attach the injector power cord to a power source.
Step 2 Connect an unpowered Ethernet cable from a switch to the IN port on the injector.
Step 3 Connect an Ethernet cable from the injector’s OUT port to the radio node. The injector will
now inject power onto a pair of wire pairs in the cable. The radio node will expect a
nominal 48V DC input (57V max) from the PoE+ injector. The Phihong POE36U-1AT PoE+
power injector typically supplies 57V maximum.
SCSN 8000
PoE Switch
Out
In
SCSN 8000
PoE Switch or
PoE Injector
PoE Injector
Non PoE Switch
OUT
IN
CONNECT
PoEPLUS
ON