User's Manual
Table Of Contents
- Table of Contents
- About this Manual
- System Overview
- System Specifications
- Radio Node Models
- Antennas
- Ports
- The Top-Panel LED
- Input Power
- Select the Radio Node Location
- Installation and Mount Bracket Assembly
- Boot Sequence and Services Node Communication
- Radio Node LED Boot Sequence
- Radio Node LED Management
- The SpiderCloud Documentation Set
- Appendix A: UMTS Antenna Patterns
- Appendix B: LTE Antenna Patterns
SpiderCloud Radio Node - SCRN-310 Hardware Installation Guide
SpiderCloud Wireless, Inc.
17
Completing the Installation
Step 1 Attach a padlock or cable tie wrap through the cutout lock holes in the mount bracket and
pedestal base.
Figure 16 Padlock and Lock Holes
The lock in the above figure is shown schematically. The orientation is for illustration purposes (not
accurate) since the bracket is typically wall or ceiling mounted.
Step 2 The radio node boots up and attempts to connect to the services node. Refer to Boot
Sequence and Services Node Communication on page 18 for more information.
Detaching the Radio Node from the Mount Bracket
To remove the radio node from the bracket assembly
Step 1 If needed, remove the padlock or cable tie wrap securing the radio node.
Step 2 Depress the spring clip on the pedestal base and slide the radio node out of the mount
bracket.
Step 3 Detach the RJ-45 clip from the Ethernet port and remove the cable from cable brackets
and cable opening.