User's Manual
Table Of Contents
- Table of Contents
- About this Manual
- System Overview
- System Specifications
- Radio Node Models
- Antennas
- Ports
- The Top-Panel LED
- Input Power
- Select the Radio Node Location
- Installation and Mount Bracket Assembly
- Boot Sequence and Services Node Communication
- Radio Node LED Boot Sequence
- Radio Node LED Management
- The SpiderCloud Documentation Set
- Appendix A: UMTS Antenna Patterns
- Appendix B: LTE Antenna Patterns
SpiderCloud Radio Node - SCRN-310 Hardware Installation Guide
SpiderCloud Wireless, Inc.
14
Figure 10 Attach the Mount Bracket
Step 2 Insert the RJ-45 connector into the Ethernet port as shown in Figure 13. Route the
Ethernet cable through the cable guides and pedestal base cable opening and through the
cable guides as shown in Figure 11:
Figure 11 Route and Terminate the Cable
Step 3 Press the cable into the cable guides until the guides securely snap around the cable.
Ensure that there is no cable slack and that there is sufficient cable bend radius.
Step 4 Slide the pedestal base of the radio node into the groove opening in the mount bracket.
When the pedestal reaches the end of the trough, a spring clip will secure the unit into
place.
Transmit Side
RJ-45 Connector in Ethernet Port
Cable
Opening
Cable
Guides
Spring
Clip