The Air Hogs™ Zero Gravity™! Wall Climber defies gravity with its wall climbing ability! Featuring a suction throttle, that allows the wall climber ta perform full function while climbing walls.
WHILE DRIVING YOUR ZERO GRAVITY™ WALL CLIMBER, MAKE SURE TO OBEY THESE RULES NOTE: ONLY USE ON SMOOTH, CLEAN SURFACES AND CLEAN THE TIRES WITH A DAMP RAG BEFORE EACH USE. DO NO’ T RUN ON DAMP SURFACES, 2 Only drive on empty walls, {no hanging pictures or other obstacles) and avoid driving an walls that have something underneath them. Stand at least 6 feet from the wall. 3 ~ DO NOT drive over wall caskets, light switches or other obstructions, Do not drive close to or off the edge of the wall.
Turn the ON/OFF switch on the Vehicle © “ON”, 2. 3. Drive vehicle Fans will towards automatically wall with the engage once Joysticks in the vehicle the forward reaches g 45° position, incline on the wall ; 4 5. Nee wall If your wall has baseboard trim at the Climber is bottom of the wall, the vehicle may not parallel to the te able to make the transition, Use the cut out ramp on the insert of the package to bridge the gap as shown. IMPORTANT: Place your ramp as tight to the wall as possible.
By pushing the joystick on the Controller, you can make your Wall Climber spin around on the spot. J RIGHT LEFT SPIN SPIN Left joystick forward Left joystick back Right joystick back Right joystick forward Push the LEFT joystick forward and the RIGHT joystick backward to make the vehicle spin clockwise. 3 Push the LEFT joystick backward and the RIGHT joystick forward to aka the vehicle spin counter clockwise. NOTE: On the wall the vehicle may spin toward the ground.