Vertical Tail Wing Helicopter oN Landing Skids CAUTION ELECTRICALLY OPERATED PRODUCT: peg eg Ee Fe) age. As with all metric products, precautions should be observed during handling and use to prevent elector shock, INPUT : AC 1207 601Z Ji CURE SR PLEASE READ THESE INSTRUCTION BEFORE FLYING! ADULT SUPERVISION Prop RECOMMENDED. Engine Fuselage Charger HELICOPTER BATTERY INFORMS! CONTROLLER BATTERY INSTALLATION + Charge the Air Hogs? Hellx™ battery only with the provided Air Hogs® Lithium Polymer Charger.
CHARGING YOUR HELIX™ HELIX . Make sure that your Helix™ helicopters “ON/OFF” switch is in the “OFF” position. , Plug the charger into a wall outlet, Connect the “charge cable” to the Helix™ charging port. Make sure cable plug aligns with chagrin port. When charging, a red LI light on the helicopter will flash and when the charging is completed, the fight will turn “OFF”, wn Charge ON/OFF" an Switch 1. Extend the controller antenna fully.
HOVERING YOUR HELIX™ HELICOPTER 1. Slowly push on the throttle until the helicopter takes off from the ground. 2, The helicopter will always hover slowly forward and ira bit of a turn either right or left, Hovering Left or Hovering Right FLYING YOUR HELIX™ HELICOPTER {IMPORTANT: TQ BEST FLY THE HELICOPTER, DIRECTIONAL INPUTS NEED TO BE SPACED OUT AND ACTIVATED WHEN THE HELICOPTER 1S FLYING RELATIVELY STABLE.
REPAIRS The Hellx™ helicopter Is quipped with folding rotors to prevent damage when the helicopter fans, Reset the rotor positions as shown. Clear tape can be used fo repair the helicopter fuselage. te A Divisible « NEVER leave the Hellx™ unattended at any time while being charged or discharged. + The charger will become slightly heated while charging. Allow sufficient free space around the charger.
Asst. #44184 NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.