User's Manual

WARNING:
Read Carefully
!
1. On the Line Winder Remote, push the Spool Lock Lever
to the DOWN position. The spool will now be unlocked
and string will pull easily from the spool. See Figure 5.
2. Attach the clip at the end of the string from the Line Winder
Remote to the Steering Servo Ring as shown in Figure 6.
3. Turn Kite “ON”. ON/OFF switch is on the Steering Servo.
IMPORTANT: Kite will move up & down and to left or right.
Please make sure there are NO obstacles or dangerous objects
in your flying area.
HOW TO FLY THE RC KITE
HOW TO HOLD
THE LINE WINDER REMOTE
Figure 7
IMPORTANT GUIDELINES FOR SAFE KITE OPERATION – ADULT SUPERVISION RECOMMENDED
Do not operate near electric wires, power lines or power poles due to risk of electric shock.
Do not operate in a small or confined space with people nearby.
Do not operate in stormy or wet weather – Avoid harsh winds and electrical storms.
Fly kite in a BIG open space with no obstacles, trees, buildings or people nearby.
At least 50 metres (55 yards) of open space is required in front and to the sides of the kite operator.
Large buildings or mountains may adversely affect kite flying due to wind turbulence.
Do not operate near water (ocean, river, pond, etc.).
For the best results, please operate kite while wind speed is 2-5 metres (2-5.5 yards) per second (5-12 miles per hour) maximum.
Wind speed higher than the recommended range will cause unstable flight, loss of control and crashing.
You may actually hear the kite string “hum” (a phenomenon called resonant frequency) in overly strong winds.
“Humming” noise is a sign that tells you the wind force is too strong. Retrieve the kite before loss of control.
1. Squeeze Latch to open Battery Door
at bottom of Steering Servo.
2. Insert 2 new AAA alkaline batteries
following the polarity (+ & -) orientation
shown in the drawing.
3. Close Battery Door – make sure it latches.
HOW TO
INSTALL
BATTERIES
IN STEERING
SERVO
Figure 5
Figure 6
1. Push Spool Lock Lever to DOWN
position to UNLOCK the spool as
shown in Figure 7 (turning the crank
will re-lock the spool).
2. Press Spool Tension Trigger as
string is pulled out so that string
never becomes too LOOSE causing
tangles on the spool.
3. Kite string can now be pulled
freely off the unlocked spool.
If a tangle occurs:
Turn crank to lock spool, press
trigger continuously, unlock spool,
& pull string out steadily until all
tangles are pulled out.
Page 3
Steering
Servo
Battery
Door
Latch
Line Winder Remote
Spool Lock Lever
UNLOCK
Kite String
Connection to
Steering Servo
To Line
Winder
Remote
Kite ON/OFF Switch
Press Spool
Tension Trigger
to keep tension
on outgoing
string
UNLOCK
RC Stunt
Switch
Spool Tension
Trigger
Spool
Crank
Handle
Spool Lock Lever
(shown in the locked
position for flying)
KITE ASSEMBLY
(continued)
In case the Steering
Servo needs to be
repaired or replaced:
Squeeze Locking Tab to
slide Steering Servo up
and off the Keel as
shown.