Check out our amazing INSTRUCTIONAL ONLINE VIDEOS HERE: www.potterycool.com Découvrez nos incroyables TUTORIELS VIDÉO EN LIGNE ICI : www.potterycool.
a CAUTION! Hair Entanglement a MISE EN GARDE ! Les cheveux peuvent se coincer. • • • • • • • • • • • • • • Tie back and cover hair and secure loose clothing prior to play. Do not place any other objects on the wheel while it is spinning. Adult Supervision Advised. Projects are for decorative purposes only. Do not eat, drink, heat or cook with your creations. Avoid contact with eyes.
JEWELLERY HOLDER 1. Insert the round core and round sleeve into the turntable. 2. Center clay disk on sleeve and press the sides to form the clay around the sleeve. Avoid pressing too hard on top edge. If holes or cracks form, don’t worry - you can patch with a piece of clay. 3. Turn the machine to “|” (slow) and spray the clay with water. (10-12 sprays) 4. Cup your hands around the clay and apply strong pressure on each side until the clay becomes smooth and even. 5.
SMART PHONE SPEAKER 1. Insert the cone core and cone sleeve into the turntable. 2. Center clay disk on sleeve and press the sides to form the clay around the sleeve. Avoid pressing too hard on top edge. If holes or cracks form, don’t worry - you can patch with a piece of clay. 3. Turn the machine to “|” (slow) and spray the clay with water. (10-12 sprays) Cup your hands around the clay and apply strong pressure on each side until the clay becomes smooth and even. 4.
CUPCAKE PENCIL HOLDER 1. Insert the round core and round sleeve into the turntable. 2. Center clay disk on sleeve and press the sides to form the clay around the sleeve. Avoid pressing too hard on top edge. If holes or cracks form, don’t worry - you can patch with a piece of clay. 3. Turn the machine to “|” (slow) and spray the clay with water. (10-12 sprays) 4. Cup your hands around the clay and apply strong pressure on each side. Keep working the clay down to the base until clay becomes smooth and even.
PUPPY PICTURE HOLDER 1. Form half of a disk of clay into a ball with your hands and place in center of the turntable. 2. Turn the machine to “|” (slow), spray with water (5-10 sprays) and lightly form the ball into a dome shape. Spray water as needed. 3. Turn the machine OFF and remove from turntable using knife. 4. Cut a slot into the dome - this will be where your picture will sit. 5. Add puppy details using excess clay and tools. 6. Completely dry overnight before painting.
TURTLE DISH 1. Form half of a disk of clay into a ball with your hands and place in center of the turntable. 2. Turn the machine to “|” (slow), spray with water (5-10 sprays) and press on each side until ball looks smooth and round. Spray water as needed. 3. Press your finger into the top until a shallow indent forms. 4. Turn the machine “0” (off) and remove from turntable using the knife tool. 5. Add turtle details using excess clay and tools. 6. Completely dry overnight before painting.
4 x C (LR14) batteries 4 piles alcalines C (LR14) BATTERY REPLACEMENT: Ensure machine is in OFF position. Open the battery door with a screwdriver. If used or spent batteries are present, remove these batteries from the unit. Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment. Replace battery door securely. Check your local laws and regulations for correct recycling and/or battery disposal.
