Data Sheet

SPNYL01-X Bluetooth module datasheet
www.spintly.com 15
10. Qualification and approvals
10.1. United States (FCC)
The SPNYL01-X has received Federal Communications Commission (FCC) CFR47 Telecommunications,
Part 15 Subpart C “Intentional Radiators” modular approval in accordance with Part 15.247 Modular
Transmitter approval. The modular approval allows the end user to integrate the module into a
finished product without obtaining subsequent and separate FCC approvals for intentional radiation,
provided no changes or modifications are made to the module circuitry. Changes or modifications
could void the user’s authority to operate the equipment. The end user must comply with all of the
instructions provided by the Grantee, which indicate installation and/or operating conditions
necessary for compliance.
The finished product is required to comply with all applicable FCC equipment authorizations
regulations, requirements and equipment functions not associated with the transmitter module
portion. For example, compliance must be demonstrated to regulations for other transmitter
components within the host product; to requirements for unintentional radiators (Part 15 Subpart B
“Unintentional Radiators”), such as digital devices, computer peripherals, radio receivers, etc.; and to
additional authorization requirements for the non-transmitter functions on the transmitter module
(i.e., Verification, or Declaration of Conformity) (e.g., transmitter modules may also contain digital
logic functions) as appropriate.
Note:
Modification to this product will void the users’ authority to operate this equipment.
The OEM is still responsible for verifying end product compliance with FCC Part 15, subpart B limits
for unintentional radiators through an accredited test facility.
10.1.1. Labelling and user information requirements
The SPNYL01-X is assigned the FCC ID number: 2A3ZU-SPNYL01
If the FCC ID is not visible when the module is installed inside another device, then the outside of the
finished product into which the module is installed must also display a label referring to the enclosed
module. This exterior label can use the following or similar wording:
Contains FCC ID: 2A3ZU-SPNYL01
In addition to marking the product with the appropriate FCC ID, the end product user manual may
also require specific information based on the digital device classification. Refer to the FCC Rules, Title
47, Subchapter A, Part 15, Subpart B, Chapter §15.105 for specific wording of the notices.
10.1.2. RF exposure
All transmitters regulated by FCC must comply with RF exposure requirements. KDB 447498 General
RF Exposure Guidance provides guidance in determining whether proposed or existing transmitting
facilities, operations or devices comply with limits for human exposure to Radio Frequency (RF) fields
adopted by the Federal Communications Commission (FCC).
This module is approved for installation into mobile and/or portable host platforms and must not be
co-located or operating in conjunction with any other antenna or transmitter except in accordance
with FCC multi-transmitter guidelines. End users must be provided with transmitter operating
conditions for satisfying RF Exposure compliance.
10.2. European Union regulatory compliance
Information about regulatory compliance of the European Union for the SPNYL01-X module is
available in the SPNYL01-X Declaration of Conformity.