Data Sheet

SPNYL01-X Bluetooth module datasheet
www.spintly.com 20
• Antennas
The SPNYL01-X is an BLE Module beams signals and communicates with its antenna, which is PCB
Antenna and External 2.4Ghz FPC antenna. Antenna could not be in no load state when module is
working. During debugging, it is suggested to add 50 Ohms load to the antenna port to avoid damage
or performance degradation of the module under long-time no-load conditions
• Label and Compliance information
The final end product must display the following content in the visible area
Host must Contains FCC ID: 2A3ZU-SPNYL01. If the size of the end product is larger than 8x10cm, then
the following FCC part 15.19 statement has to also be available on the label: The device complies with
part 15 of FCC rules. Operation is subject to the following 2 conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may cause
undesired operation
• Information on test modes and additional testing requirements
Data transfer module demo board can control the EUT work in RF test mode at specified test channel.
• FCC ID Location:
OEM Warning statement (Module)
The modular transmitter must be equipped with either a permanently affixed label or must be
capable of electronically displaying its FCC identification number：
If using a permanently affixed label, the modular transmitter must be labelled with its own FCC
identification number, and, if the FCC identification number is not visible when the module is installed
inside another device, then the outside of the device into which the module is installed must also
display a label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains Transmitter Module FCC ID: 2A3ZU-SPNYL01.” Any similar wording that expresses
the same meaning may be used. The Grantee may either provide such a label, an example of which
must be included in the application for equipment authorization, or, must provide adequate
instructions along with the module which explain this requirement. In the latter case, a copy of these
instructions must be included in the application for equipment authorization.
• Additional testing:
The OEM integrator is still responsible for the FCC compliance requirement of the end product,
which integrates this module. Appropriate measurements (e.g. 15 B compliance, 15C
intentional emissions (Fundamental + Out-of-Band Emission)) and if applicable additional
equipment authorizations (e.g. Verification, DoC) of the host device to be addressed by the
integrator/manufacturer.
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2) This device and its antenna(s) must not be co‐located with any other transmitters except in
accordance with FCC multi‐transmitter product procedures. Referring to the multi‐transmitter policy,
multiple‐transmitter(s) and module(s) can be operated simultaneously without C2P.