User's Manual Part 2

Nomad User’s Manual Chapter 9 – Voice Quality Configuration Options

 The test sequence starts with Handset 1 sourcing audio to Handset 2. Assuming Alternate

channels after each cycle has been selected, in the next cycle Handset 2 will source audio

to Handset 1.

 The Average Delay and Median Delay will be plotted for each direction on the Delay

Times (ms) / Cycle chart.

 Detailed statistics for each test cycle are available in the Cycle History area.

Figure 9-15 - Voice Delay Testing

While monitoring the data during testing, be mindful of the following:

 Confirm that each individual cycle has completed and that Nomad has reported data.

 Confirm that the Delay Times chart updates for each cycle.

The test will stop after the configured number of Cycles has been completed. Alternatively, use the

Stop button to end the test at any time as desired.

Delay test results can be found on the Delay Performance Summary tab of the output report.

Note: Delay measurements greater than 250 milliseconds round-trip are considered “high” and are

generally detectable during standard conversation.