User's Manual Part 2

Nomad User’s Manual Chapter 10 – Call Performance Configuration Options

10.3 Mobile-to-Mobile Testing

In a Mobile-to-Mobile test, one handset makes calls that are received by a second handset attached

to a different channel on the same Spirent ME unit. To perform Mobile-to-Mobile call performance

testing:

 Determine which handset will be the originating device and which handset will be the

receiving device. All call performance testing operates via Bluetooth connection.

 On the Nomad Test Setup screen, configure Channel 1 as a Mobile-to-Mobile Originate

task with the following Call Campaign settings:

o Receiving Device: Receiver on Channel 2.

o Number to dial: The phone number of the receiving test device.

o Access Timeout: A call attempt that has not connected within this amount of time

will be classified as an Access Timeout event.

o Duration: The length of each call in the test sequence.

o Wait Time: The amount of idle time between the end of one call and the start of the

next call.

o Attempts: The number of calls to attempt in this call sequence.

 Note: All Mobile-to-Mobile call performance tasks are Synchronous. Therefore, there is no

option to select the Call Initiation Mode.

Figure 10-5 - Mobile-to-Mobile Originated Call Campaign Dialog

 Channel 2 will automatically be configured as a Mobile-to-Mobile Receive task. Confirm

that the Incoming number in the Call Campaign dialog matches the phone number of the

Mobile-to-Mobile Originating device. The settings here are pulled automatically from the

Mobile-to-Mobile Originate task and are not editable here. These settings will change

automatically when changes are made to the Mobile-to-Mobile Originate task.