User's Manual
Table Of Contents
- 1: Introduction
- 1.1 Documentation notes
- 1.2 Product introduction
- 1.3 General product handling and operation
- 1.3.1 Powering on/off and sleep mode
- 1.3.2 Attaching, detaching, and handling modules
- 1.3.3 Attaching the Wi-Fi antenna
- 1.3.4 Attaching the strap
- 1.3.5 About the touchscreen display
- 1.3.6 Selecting the active interface
- 1.3.7 Starting a function or test
- 1.3.8 Stopping a test
- 1.3.9 Saving results
- 1.3.10 Interpreting results
- 1.4 Maintenance
- 1.5 Technical support
- 2: Wi-Fi Testing Menu
- 3: 10/100 Testing Menu
- 4: System Menu
- 5: IP and Video Testing
- 5.1 IP Network Setup
- 5.2 Connection Information
- 5.3 Ping
- 5.4 Traceroute
- 5.5 Web Browser
- 5.6 IP Video testing
- 6: Specifications
Base Unit User Guide Issue 1 Tech-X Flex™
1-16 1: Introduction
Intro
Wi-Fi
10/100
System
IP/Video
Specs
1.4.1 Battery replacement
Users may perform field replacement of the battery pack. Note the following:
• New battery packs should be ordered from Spirent.
• Batteries contain hazardous contaminants and should be disposed of according to local regulations.
It may be illegal to discard batteries in the general trash.
To replace the battery pack
1. On the back of the unit, remove the two battery pack anchor screws, under the base of the kickstand.
Be careful not to accidentally remove the unit cover screws (see Figure 1-9).
Figure 1-9 Battery pack screws
2. Gently slide the battery pack from the bottom of the unit.
Battery pack
screws
Unit cover
screw