User's Manual
Table Of Contents
- 1: Introduction
- 1.1 Documentation notes
- 1.2 Product introduction
- 1.3 General product handling and operation
- 1.3.1 Powering on/off and sleep mode
- 1.3.2 Attaching, detaching, and handling modules
- 1.3.3 Attaching the Wi-Fi antenna
- 1.3.4 Attaching the strap
- 1.3.5 About the touchscreen display
- 1.3.6 Selecting the active interface
- 1.3.7 Starting a function or test
- 1.3.8 Stopping a test
- 1.3.9 Saving results
- 1.3.10 Interpreting results
- 1.4 Maintenance
- 1.5 Technical support
- 2: Wi-Fi Testing Menu
- 3: 10/100 Testing Menu
- 4: System Menu
- 5: IP and Video Testing
- 5.1 IP Network Setup
- 5.2 Connection Information
- 5.3 Ping
- 5.4 Traceroute
- 5.5 Web Browser
- 5.6 IP Video testing
- 6: Specifications
Tech-X Flex™ Base Unit User Guide Issue 1
2: Wi-Fi Testing Menu 2-7
Intro
Wi-Fi
10/100
System
IP/Video
Specs
Once the unit successfully connects, the network parameters are saved in memory under the respective
SSID (name).
NOTE: If you have trouble connecting, see If you cannot connect (troubleshooting tips) on page 2-3.
Setup - Connect (Wi-Fi Setup)
Table 2-1 Connect (Wi-Fi Setup) - Setup parameters page 1
Parameter Description
SSID (Service Set Identifier) Network name.
Channel Number Channel used by the network, typically 1 to 11 with variances possible based on the
country of operation and applicable regulations. A Wi-Fi connection is based on a
single channel which you must have correctly specified.
Network Type Type of network:
INFRASTRUCTURE - A centralized network where the unit will negotiate with a
single access point that manages the network overall.
NOTE: Connection to “adhoc” Wi-Fi networks is currently not supported.
Security Type Type of security in use on the network:
• WEP-64 - Wired Equivalent Privacy using a 40-bit key.
• WEP-128 - Wired Equivalent Privacy using a 104-bit key.
• NONE - No security (open access)