User's Manual
Table Of Contents
- 1: Introduction
- 1.1 Documentation notes
- 1.2 Product introduction
- 1.3 General product handling and operation
- 1.3.1 Powering on/off and sleep mode
- 1.3.2 Attaching, detaching, and handling modules
- 1.3.3 Attaching the Wi-Fi antenna
- 1.3.4 Attaching the strap
- 1.3.5 About the touchscreen display
- 1.3.6 Selecting the active interface
- 1.3.7 Starting a function or test
- 1.3.8 Stopping a test
- 1.3.9 Saving results
- 1.3.10 Interpreting results
- 1.4 Maintenance
- 1.5 Technical support
- 2: Wi-Fi Testing Menu
- 3: 10/100 Testing Menu
- 4: System Menu
- 5: IP and Video Testing
- 5.1 IP Network Setup
- 5.2 Connection Information
- 5.3 Ping
- 5.4 Traceroute
- 5.5 Web Browser
- 5.6 IP Video testing
- 6: Specifications
Tech-X Flex™ Base Unit User Guide Issue 1
5: IP and Video Testing 5-7
Intro
Wi-Fi
10/100
System
IP/Video
Specs
5.5.1 Setup - Web Browser
5.6 IP Video testing
IP video testing support includes:
• Subjective quality assessment of viewer experience
• Comprehensive statistics on multimedia transport streams
• Video channel change times
Video testing is supported on IP multicast streams using the MPEG codec. During testing, the unit joins
the stream and emulates an IPTV subscriber, providing a comprehensive view of the subscriber
experience.
NOTE: Depending upon the test interface, passive testing of video quality for unicast and multicast
streams may also be available.
Specific video functions include:
Table 5-5 Web Browser - Setup parameters
Parameters Description
URL Target address of the web page to load, either a dotted IP address or a URL if a
DNS is available. For example:
208.22.58.142
www.google.com
Note the following:
• When entering a URL, case is unimportant because all characters are
converted to lower case when the browser is launched.
• The unit remembers the recent addresses you entered.